Hydrovac Services in Burlington: Industrial Corridor Daylighting, Fiber Potholing & Catch Basin Programs From Aldershot to Appleby

Hydrovac excavation is non-destructive digging that uses 3,000-4,000 PSI pressurized water to cut soil loose and 27 inch Hg vacuum to lift the slurry into a debris tank, exposing buried gas, hydro, fiber and water lines without a steel bucket ever touching them. We run it on Vactor 2100i and Vac-Con V390 trucks for utility potholing, backfill removal around live services, test pits before auger work, and confined space digs where a backhoe cannot fit. Every job starts with an Ontario One Call locate and runs under OHS Reg 213/91 construction protocol plus CSA Z247 ground disturbance standards. Depth, size and material logged with photos at every exposure, with 100% first-visit utility coordination approval across 2,000+ GTA projects.

A utility GC on Finch Ave W found that out the easy way. We exposed 14 live gas junctions on their site using the 3,500 PSI wand, logged depth and offset at every one, and the Enbridge inspector signed off on all 14 on the first visit. The whole job came in at $3,200 CAD. Trust us, you're in good hands. Nine times out of ten, this is where the previous contractor cut a corner and left a $50K strike liability on the table.

Daylighting is non-destructive utility exposure using 3,500 PSI pressurized water and 27 inch Hg vacuum to visually verify the exact position, depth and material of buried fiber optic cable, high-pressure gas distribution mains, electrical duct banks, cast iron water mains and tracer wire before any bore, drill or trench cuts through them. We work from Subsurface Utility Engineering Quality Level A standards, inside the locate tolerance zone defined by Ontario One Call, and log depth, size and condition for every exposure. The result is a dig that proceeds with real coordinates, not paint marks. We daylight for Enbridge Gas pre-dig, Toronto Hydro vault access, Bell Canada fiber corridor work, HDD and trenchless crossings, and emergency water main depth confirmation under CSA Z247.

A telecom GC on the Toronto Port Lands had a dig-in with another crew the week before they called us. We exposed 180 ft of buried fiber in three days using 3,500 PSI and 27 inch Hg vacuum, logged depth every metre, and the ON1Call locator signed off on the first visit. The $18,400 CAD invoice held to the published rate card. Trust us, this is where the first contractor cut a corner.

Sewer and culvert cleaning combines high-pressure sewer jetter nozzles, flexible hose reels on Vactor sewer units and 27 inch Hg vacuum recovery to clear silt, grease, roots and construction debris from municipal storm sewers, catch basins, interceptor vaults, oil-grit separators, culvert pipes and commercial grease traps across the GTA. We work to Toronto Water, Peel Region and Halton Region catch basin program specifications, document every inlet and outlet with before-and-after photographs, and record disposal volumes against MECP waste manifests. Sediment sumps on our Vactor 2100i trucks capture solids before transport so one visit handles the jet, the vacuum and the inspection record. Grease trap cleanouts, storm drain emergency flushing and culvert flushing around CSA concrete pipes all handled in-house with Hannay reel systems and licensed slurry disposal.

A municipal procurement officer in Vaughan handed us 42 silted culverts on a Highway 400 shoulder maintenance package. We ran two 6,000-gallon trucks for two days, flushed every inlet and outlet, and delivered a photo log plus Halton Region disposal records before the invoice went out at $14,600 CAD. Every culvert cleared the first visit. Nine times out of ten, this is where the previous contractor left half the job on the record.

Emergency hydrovac covers after-hours response for water main breaks, sewer backups, insurance claim exposure, curb stop access and construction site utility strikes across the Toronto GTA, 24 hours a day, seven days a week. We dispatch within 2 hours of the call, mobilize a Vactor 2100i or Vac-Con V390 truck with a Red Seal operator, and run 3,500 PSI water with 27 inch Hg vacuum to expose the cause of loss, dewater the site, and deliver a time-stamped photo log for your insurance adjuster or restoration contractor. Published after-hours rate is $450-$650 CAD per hour with a 4-hour minimum callout. Toronto Water, Peel Region and Halton Region coordination handled, sanitary backup containment managed to Ontario Reg 406/19 slurry disposal standards.

An insurance adjuster working a Scarborough plaza sewer backup called us at 11:00 PM in January. Truck was on site in 90 minutes, backup vacuumed, blockage exposed and photographed, and the adjuster had the file by 06:00 the next morning. Six hours of after-hours work, $3,100 CAD invoice, case closed. Trust us, you're in good hands on the overnight shift. Nine times out of ten, that is when the previous contractor could not pick up the phone.

Contaminated soil removal is hazmat-rated hydrovac work that uses 3,500 PSI pressurized water and 27 inch Hg vacuum to lift petroleum-impacted, heavy-metal-impacted and salt-contaminated soil from Toronto brownfield sites, Phase II Environmental Site Assessment digs, underground storage tank removals and spill response calls, straight into a sealed debris tank for direct haul to an MECP-licensed receiving facility. We run Vactor 2100i and Super Products Mud Dog trucks with hazmat-trained operators who hold confined space entry tickets and CSA Z247 ground disturbance training. Every load travels under Ontario Regulation 406/19 (Excess Soil Management) with a complete soil characterization package: ASTM D1586 sampling, Table 1-9 analytical results tied to the manifest and a receiving-site acceptance letter in your project file.

A Toronto brownfield developer needed 48 cubic metres of petroleum-impacted soil removed from an infill site in East Toronto before Phase II ESA sign-off. We staged a 6,000-gallon Vactor 2100i with a hazmat-trained operator, ran four truck turnovers across two days, delivered every load to a Class 2 MECP-licensed receiving facility with manifest records, and the environmental consultant signed off on the first visit. Invoice came in at $14,800 CAD. Nine times out of ten, this is where a conventional excavator would have left a documentation gap.

Hydrovac rentals cover operated truck rental by the half-day, full day, week or project, with a Vactor 2100i or Vac-Con V390 unit and a Red Seal certified operator who holds a DZ licence, CSA Z247 ground disturbance training and a confined space entry ticket. Every rental includes mobilization, standby time, published fuel and disposal rates, and a tank capacity worksheet for your project manager. We quote half-day rates at $1,120-$1,800 CAD, full 8-hour days at $2,240-$3,600 CAD, and full-week project rates at $12,000-$22,000 CAD. All three trucks TSSA pressure vessel compliant, all operators WSIB registered, no subcontractors on your site. Bare rental is not offered because we never put an untrained operator behind the wand.

A commercial GC on a four-week downtown foundation project needed a dedicated hydrovac truck and operator from Monday to Friday across the entire schedule. We quoted $18,400 CAD per week for the Vactor 2100i plus the operator, delivered on time every day, and the project finished a full week ahead of the original schedule. Trust us, you're in good hands. It still blows our mind when a job comes in that clean.

Pile hole excavation is non-destructive digging that uses 3,000-4,000 PSI water and 27 inch Hg vacuum to clear the exact footprint for helical piles, caissons, sonotube footings and retaining wall anchors to foundation depth, without striking buried utilities on their way down. We work past frost depth on winter projects using heated water, maintain plumb tolerance on every hole with a laser rig, and manage spoil directly into the debris tank so there is no mess on the slab or landscape. Vac-Con V390 trucks on tight residential lots, Vactor 2100i on commercial foundation work, every hole documented for your foundation footing engineer and compliant with OHS Reg 213/91 construction excavation and CSA Z247 ground disturbance standards.

A foundation GC near Pearson Airport had 18 helical pile locations to clear through buried telecom and electrical before the auger crew could start. We prepped every one in a single 10-hour day using the 3,500 PSI wand, logged depth and offset, and the auger rig followed without a single strike. Invoice came in at $9,200 CAD, matching the published day rate exactly. Trust us, this is why the GC called us back for the next three jobs.

Slot trenching is narrow non-destructive excavation that uses 3,500 PSI pressurized water and 27 inch Hg vacuum to cut linear trenches between 4 and 8 inches wide for fiber optic lateral runs, electrical conduit, irrigation line installation and utility interconnect work, through congested right-of-ways where open-cut would hit three or four buried services. We run X-Vac X-13 and Vactor 2100i trucks on asphalt saw-cut edges, minimize spoil with controlled recovery into the debris tank, and reinstate the surface to municipal right-of-way permit specification. Every slot goes in past a tracer wire with recorded depth. Fiber optic trenching on the Highway 7 tech corridor, electrical conduit runs through downtown parking garages and conduit runs across municipal easements all handled with Red Seal certified operators.

A fiber installer on the Markham tech corridor needed 420 ft of new conduit through a shared right-of-way with Bell, Hydro One, Enbridge and the municipal storm sewer. We exposed every crossing first, then cut the slot trench in four days using the 3,500 PSI wand and recovered spoil continuously. $22,800 CAD invoice held to the rate card. Everytime we do slot work in that corridor, it goes in without a nick.

Vacuum truck services use high-capacity 2,500-6,000 gallon tanks on Vactor 2100i and Super Products Mud Dog trucks to recover wet slurry, dry debris, industrial sludge, liquid industrial waste and spent drilling fluids from job sites across the Greater Toronto Area. We run 27 inch Hg suction with cyclonic filtration and decant systems that separate solids before transport, so one truck can handle a pit, a sump, a lift station and a confined space in the same shift. Every load leaves with a waste manifest to a licensed MECP disposal site, and every TSSA-compliant pressure vessel on our fleet carries current inspection records. Industrial tank cleaning, construction site debris, oil-grit separators and interceptor vaults handled with Red Seal certified operators and confined space entry tickets.

A food manufacturer in Mississauga needed their 15,000-gallon brine tank cleaned during a 24-hour maintenance window. We staged two 6,000-gallon trucks, ran four turnover cycles on the sludge dewatering circuit, and had the tank inspection-ready by 06:30 the next morning. Final invoice was $8,400 CAD. Everytime we do these overnight shifts, we treat the clock like a published rate card. It still blows our mind when we finish one of these on schedule.